But I guess they hadn t checked the cameras on it. I read that the update was released before it was done sk it wasn't behind the official release schedule and blocked it on my machines till people in the group said Beyond worked ok on it. Evan after i used it for a year fine before the update. Even microsoft's kenex configuration utility says there is a problem in the usb driver but suggests that the usb controller is incompatible with the camera. Microsoft admitted they made a mistake in the usb drivers on the creatures up date and posted a notice to modify a couple registry values but after checking 3 of my win 10 machines none of those even had the entry they mentioned and adding the correct entry didn't have any effect, The kenex just can't be seen after the update unless you re install everything in compatibility mode for 7. The Sdk and drivers have to be uninstalled and re installed using the windows compatibility mode for windows 7 to make them work again. Ĭlick to expand.It has been resolved, The equipment worked fine before the Microsoft creators update for win 10 but after that the drivers no longer saw the usb device. Any light you can shed on this will be appreciated. So they never got that working right either. And I have noticed my cell phone going dead and then shutting down to recharge while its plugged in to my laptop with the usb power options set to always on. The entry had a name of AiChargerPlus so apparently is for usb cellphone support.

From what I read on a foram the Creators update screwed up the usb driver but deleting the value I haven't got on any of my computers will temporarily fix it. That was from microsoft dated Jand admitted they had a problem and they were working on it. I searched and found a post showing a registry change to LowerFilters string but that value doesn't exist in my machines. But it can no longer see the sensor on the usb port. Beyond has the icon that indicates the drivers are ok. After reinstalling the drivers, no difference. Also it said the software isn't installed. and a link for system requirements that was 404. Finally downloaded a kinect configuration verifier from Microsoft and ran it on alo 3 machens and it agreed that all 3 have usb controller problems and that the usb ports may not be compatible with my hardware. Remembered seeing some at our local pawn shop. Tried it on 3 different Win 10 machines with no luck. Got out my Kinect v2 cause I finally had time to play.

360 kinect drivers for windows 1.8